LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transmission (Re0F10J) (DTC/Circuit Diagnosis) (Except Hybrid) (2 Of 2)) >> DTC/Circuit Diagnosis >> DTC P0890: TCM >> Diagnosis Procedure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK TCM BATTERY POWER SUPPLY (BACK-UP) CIRCUIT

    1. Turn ignition switch OFF.
    2. Disconnect TCM connector.
    3. Check voltage between TCM harness connector terminals and ground.
      TCM - Voltage
      Connector Terminal
      F89 45 Ground 10 - 16 V
      46

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    GO TO STEP 2  .

  2. DETECT MALFUNCTIONING ITEMS

    Check the following items:

    • Open or short circuit of harness between battery positive terminal and TCM connector terminals 45, and 46.
    • 10A fuse [No. 25, located in the fuse block (J/B)]. Refer to TERMINAL ARRANGEMENT .

    Is the inspection result normal?

    YES 

    Check intermittent incident. Refer to INTERMITTENT INCIDENT .

    NO 

    Repair or replace malfunctioning parts.

  3. CHECK INTERMITTENT INCIDENT

    Refer to INTERMITTENT INCIDENT .

    Is the inspection result normal?

    YES 

    Replace the TCM. Refer to REMOVAL AND INSTALLATION .

    NO 

    Repair or replace malfunctioning parts.