LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transmission (Re0F10J) (DTC/Circuit Diagnosis) (Except Hybrid) (2 Of 2)) >> DTC/Circuit Diagnosis >> DTC P0826: Up And Down Shift SW >> Component Inspection >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. MANUAL MODE SWITCH

    Check continuity between CVT shift selector connector terminals.

    CVT shift selector Condition Continuity
    Terminal
    7 - 4 Manual shift gate position (neutral) Existed
    Other than the above Not existed
    8 - 4 Selector lever: DOWN (- side) Existed
    Other than the above Not existed
    9 - 4 Selector lever: UP (+ side) Existed
    Other than the above Not existed
    10 - 4 Manual shift gate position Not existed
    Other than the above Existed

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace the CVT shift selector assembly due to malfunction in manual mode switch. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals