LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 48 (Automatic Transmission (Re0F10J) (DTC/Circuit Diagnosis) (Except Hybrid) (2 Of 2)) >> DTC/Circuit Diagnosis >> DTC P0776: Pressure Control Solenoid B >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Always drive vehicle at a safe speed.

  1. PREPARATION BEFORE WORK

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION

    1. Start the engine.
    2. Drive the vehicle.
    3. Maintain the following condition for 20 seconds or more.
      Selector lever : "D" position
      Vehicle speed : 40 km/h (25 MPH) or more
      Accelerator pedal position : 1.0/8 or more
    4. Stop the vehicle.
    5. Check the first trip DTC.

    Is "P0776" detected?

    YES 

    Go to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals