LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Automatic Transmission (Re0F10E) (DTC/Circuit Diagnosis) (Except Hybrid) (2 Of 2)) >> DTC/Circuit Diagnosis >> DTC P17F0: CVT Judder (T/M Inspection) >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • DIAGNOSIS PROCEDURE  must be performed before starting "DTC CONFIRMATION PROCEDURE".
  • Always drive vehicle at a safe speed.

  1. PREPARATION BEFORE WORK

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO STEP 2  .

  2. CHECK DTC DETECTION

    1. With the throttle position 1/8, accelerate the vehicle from 0 km/h (0 MPH) to 50 km/h (31 MPH).
    2. Drive the vehicle at 50 km/h (31 MPH) constant speed for 15 seconds.
    3. Stop the vehicle with a brake force which allows the vehicle to stop in 10 to 20 seconds.
    4. Repeat steps 1 to 3 above 5 times.

    Is "P17F0" detected?

    YES 

    Go to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals