DTC Detection Logic
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
| DTC |
CONSULT screen terms
(Trouble diagnosis content) |
DTC detection condition |
Possible causes |
| P0715 |
INPUT SPEED SENSOR A
(Input/Turbine Speed Sensor A Circuit) |
When 1 is satisfied and any of 2, 3 or 4 is satisfied:
- When the following conditions are satisfied:
- TCM power supply voltage: More than 11 V
- After range change completion, it spends 2 seconds or more.
- When all of the following conditions are satisfied and this state is maintained for 5 seconds:
- Primary pulley speed: Less than 150 RPM
- Secondary pulley speed: 500 RPM or more
- When all of the following conditions are satisfied and this state is maintained for 0.5 seconds:
- 10-msec-ago primary pulley speed: 1, 000 RPM or more
- Now primary pulley speed: 0 RPM
- When all of the following conditions are satisfied and this state is maintained for 5 seconds:
- Range: D or L
- Engine speed: 450 RPM or more
- Input peed: 300 RPM or more
- Primary pulley speed: 300 RPM or more
- Secondary pulley seed: 300 RPM or more
- Differences between engine speed and primary pulley speed: More than 1, 000 RPM
- Differences between primary pulley speed and input speed: More than 1, 000 RPM
- Differences between engine speed and input speed: 1, 000 RPM or less
- Lock-up command is being given (except for slip lock-up)
- DTC other than the applicable DTC is not detected.
|
|