LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Automatic Transmission (Re0F10E) (Symptom Diagnosis & Removal And Installation) (Except Hybrid)) >> Periodic Maintenance >> CVT Fluid >> Adjustment

CVT Fluid: Adjustment

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CVT fluid : Refer to GENERAL SPECIFICATION .
Fluid capacity : Refer to GENERAL SPECIFICATION .
CAUTION:
  • During adjustment of the CVT fluid level, check CONSULT so that the oil temperature may be maintained from 35 to 45°C (95 to 113°F).
  • Maintain specified engine idle speed during CVT fluid level adjustment. Refer to IDLE SPEED .
  • Use caution when looking into the drain hole as there is a risk of dripping fluid entering the eye.
  1. Check that the selector lever is in the "P" position, then completely engage the parking brake.
  2. Start the engine.
  3. Adjust the CVT fluid temperature to be approximately 40°C (104°F).
    NOTE:

    The CVT fluid is largely affected by temperature. Therefore be sure to use CONSULT and check the "FLUID TEMP" under "TRANSMISSION" in "Data Monitor" while adjusting.

  4. While depressing the brake pedal, shift the selector lever to the entire position from "P" to "L", and shift it to the "P" position.
    NOTE:

    Hold the lever at each position for 5 seconds.

  5. Lift up the vehicle.
  6. Check that there is no CVT fluid leakage.
  7. Remove the overflow plug WHITE-1 from converter housing.
    G08682876Courtesy of NISSAN NORTH AMERICA, INC.
    ARROW : Vehicle front
  8. Install the charging pipe set (KV311039S0) (A) into the overflow plug hole.
    G08682877Courtesy of NISSAN NORTH AMERICA, INC.
    CAUTION:

    Tighten the charging pipe by hand.

  9. Install the ATF changer hose (B) to the charging pipe.
    CAUTION:

    Press the ATF changer hose all the way onto the charging pipe until it stops.

  10. Fill approximately 0.5 liter (1/2 US qt, 1/2 lmp qt) of the CVT fluid.
  11. Remove the ATF changer hose from the charging pipe, and check that the CVT fluid drains out from the charging pipe. If it does not drain out, perform charging again.
    CAUTION:

    Perform this work with the vehicle idling.

  12. When the flow of CVT fluid slows to a drip, remove the charging pipe from the converter housing.
  13. Tighten the overflow plug to the specified torque. Refer to EXPLODED VIEW .
    CAUTION:

    Never reuse O-ring.

  14. Lift down the vehicle.
  15. Stop the engine.
scientia non olet · About LEMON Manuals