LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Automatic Transmission (Re0F10E) (DTC/Circuit Diagnosis) (Except Hybrid) (1 Of 2)) >> DTC/Circuit Diagnosis >> DTC P0713: Transmission Fluid Temperature Sensor A >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Be careful of the driving speed.

  1. PREPARATION BEFORE WORK

    If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

    GO TO STEP 2. 

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start the engine.
    2. Maintain the following condition for 10 seconds or more.
      Vehicle speed : 20 km/h (12 MPH) or more
    3. Stop the vehicle.
    4. Check the first trip DTC.

    Is "P0713" detected?

    YES 

    Go to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals