DTC Detection Logic
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
| DTC |
CONSULT screen terms
(Trouble diagnosis content) |
DTC detection condition |
Possible causes |
| P0711 |
FLUID TEMP SENSOR A
(Transmission Fluid Temperature Sensor A Circuit Range/Performance) |
When any of 1 or 2 is satisfied:
- Under the following diagnosis conditions, CVT fluid temperature does not rise to 10°C (50°F) after driving for a certain period of time with the TCM-received fluid temperature sensor value between - 40°C (- 40°F) and 9°C (48.2°F).
- TCM power supply voltage: More than 11 V
- CAN communication is normal
- Engine speed: 450 RPM or more
- Accelerator pedal position: 3 deg. or more
- Vehicle speed: 10 km/h (7 MPH) or more
- U0100, P0705 and P0706 are not detected.
- Selector lever: "D" position
- When the condition of the final judgment is satisfied after satisfying that of the provisional judgment:
- Provisional judgment: All of the following conditions are satisfied within 2 seconds after the ignition switch is turned ON.
- U0073, U0100, P0712 and P0713 are not detected.
- CAN communication is normal.
- TCM power supply voltage: More than 11 V
- The difference between CVT fluid temperature and engine coolant temperature is 55°C (131°F) or more, or - 27°C (- 16°F) or less.
- Final judgment: When all of the following conditions are satisfied and this state is maintained for 300 seconds:
- Provisional judgment is satisfied.
|
CVT fluid temperature sensor |