Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK AUTOMATIC BACK DOOR MAIN SWITCH INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Disconnect automatic back door main switch connector.
   3. Check voltage between automatic back door main switch harness connector and ground.

      (+)		(-)	Voltage (Approx.)
      Automatic back door main switch
      Connector	Terminal
      M185	1	Ground	16 - 8 V

      Is the inspection result normal? 

      YES: GO TO  3.

      NO: GO TO 2.

2. CHECK AUTOMATIC BACK DOOR MAIN SWITCH CIRCUIT 
   1. Disconnect automatic back door control module connector.
   2. Check continuity between automatic back door control module harness connector and automatic back door main switch harness connector.

      Automatic back door control module		Automatic back door main switch		Continuity
      Connector	Terminal	Connector	Terminal
      B55	10	M185	1	Yes

   3. Check continuity between automatic back door control module connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B55	10		No

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

3. CHECK AUTOMATIC BACK DOOR MAIN SWITCH GROUND CIRCUIT 

   Check continuity between automatic back door main switch connector and ground.

   Automatic back door main switch		Ground	Continuity
   Connector	Terminal
   M185	3		Yes

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair or replace harness.

4. CHECK AUTOMATIC BACK DOOR MAIN SWITCH 

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 5.

   NO: Replace automatic back door main switch. Refer to "REMOVAL AND INSTALLATION ".

5. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   : Inspection End.