Work Procedure

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION: Fully understand the following items well before the road test;

Precautions: Refer to "PRECAUTION FOR BLIND SPOT WARNING/BLIND SPOT INTERVENTION SYSTEM SERVICE ".
System description for Blind Spot Warning: Refer to "BLIND SPOT WARNING (BSW) SYSTEM: SYSTEM DESCRIPTION ".
System description for Blind Spot Intervention: Refer to "BLIND SPOT INTERVENTION SYSTEM: SYSTEM DESCRIPTION ".
Normal operating condition: Refer to "DESCRIPTION ".

LDW/LDP SYSTEM ACTION TEST
Perform the LDW/LDP system action test. Refer to "INSPECTION PROCEDURE ".

: GO TO 2.
CHECK BSW SYSTEM SETTING
1. Start the engine.
2. Check that the BSW system setting can be enabled/disabled in the vehicle information display.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
: GO TO 3.

BSW SYSTEM ACTION TEST

Enable the setting of the BSW system in the vehicle information display.
Turn warning systems switch ON (warning systems ON indicator is ON).
NOTE: Blind Spot Intervention system is OFF.

Check BSW operation according to the following table.

Vehicle condition/Driver's operation				Action
Warning systems ON indicator	Vehicle speed (Approx.) [km/h (MPH)]	Turn signal condition	Status of vehicle detection within detection area	Indication on the Blind Spot Warning/Blind Spot Intervention indicator	Buzzer
OFF	-	-	-	OFF	OFF
ON	Less than approx. 29 (18)	-	-	OFF	OFF
	Approx. 32 (20) or more	-	Vehicle is absent	OFF	OFF
		OFF	Vehicle is detected	ON	OFF
		ON (vehicle detected direction)	Before turn signal operates Vehicle is detected	Blink	Short continuous beep
		ON (vehicle detected direction)	Vehicle is detected after turn signal operates	Blink	OFF

NOTE:

If vehicle speed exceeds approximately 32 km/h (20 MPH), BSW function operates until the vehicle speed becomes lower than approximately 29 km/h (18 MPH).
Time shown in the figure is approximate time.
Always Blind Spot Intervention system operates together with BSW system. Whenever Blind Spot Intervention system is turned on by pushing the dynamic driver assistance switch, BSW system also be turned on even if the BSW system is turned off. However, at this time the warning systems ON indicator remains OFF.

: GO TO 4.