Element Check

Attach probe circuit tester (ohm setting) to antenna terminal on each side.

Fig 1: Checking Antenna Terminal Using Probe Circuit Tester
Courtesy of NISSAN NORTH AMERICA, INC.
- When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.
  
  Fig 2: Pressing Foil Against Wire
  Courtesy of NISSAN NORTH AMERICA, INC.
If an element is broken, no continuity will exist.

Fig 3: Checking Broken Point Element
Courtesy of NISSAN NORTH AMERICA, INC.
To locate a break, move probe along element. Tester indication will change abruptly when probe passes the broken point.

Fig 4: Checking Broken Point
Courtesy of NISSAN NORTH AMERICA, INC.