Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK RH SIDE CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY 
   1. Turn ignition switch OFF.
   2. Disconnect around view monitor control unit connector M97 and RH side camera connector D113.
   3. Check continuity between around view monitor control unit connector M97 and RH side camera connector D113.

      Around view monitor control unit		RH side camera		Continuity
      Connector	Terminals	Connector	Terminals
      M97	65	D113	5	Yes
      	66		17

   4. Check continuity between around view monitor control unit connector M97 and ground.

      Around view monitor control unit		Ground	Continuity
      Connector	Terminals
      M97	65	-	No

   Is inspection result normal? 

   YES: GO TO  2.

   NO: Repair or replace harness or connectors.

2. CHECK RH SIDE CAMERA IMAGE SIGNAL 
   1. Connect around view monitor control unit connector M97 and RH side camera connector D113.
   2. Turn ignition switch ON.
   3. Check signal between around view monitor control unit connector M97 terminals.

      Around view monitor control unit		Condition	Reference value
      (+)	(-)
      Terminal	Terminal
      65	66	CAMERA switch is ON or shift position is R.

   Is inspection result normal? 

   YES: Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".

   NO: Replace RH side camera. Refer to "REMOVAL AND INSTALLATION ".