Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK REAR CAMERA IMAGE SIGNAL CIRCUIT CONTINUITY 
   1. Turn ignition switch OFF.
   2. Disconnect around view monitor control unit connector M97 and rear camera connector D511.
   3. Check continuity between around view monitor control unit connector M97 and rear camera connector D511.

      Around view monitor control unit		Rear camera		Continuity
      Connector	Terminals	Connector	Terminals
      M97	53	D511	5	Yes
      	54		1

   4. Check continuity between around view monitor control unit connector M97 and ground.

      Around view monitor control unit		Ground	Continuity
      Connector	Terminals
      M97	53	-	No

   Is inspection result normal? 

   YES: GO TO  2.

   NO: Repair or replace harness or connectors.

2. CHECK REAR CAMERA IMAGE SIGNAL 
   1. Connect around view monitor control unit connector M97 and rear camera connector D511.
   2. Turn ignition switch ON.
   3. Check signal between around view monitor control unit connector M97 terminals.

      Around view monitor control unit		Condition	Reference value
      (+)	(-)
      Terminal	Terminal
      53	54	CAMERA switch is ON or shift position is R.

   Is inspection result normal? 

   YES: Replace around view monitor control unit. Refer to "REMOVAL AND INSTALLATION ".

   NO: Replace rear camera. Refer to "REMOVAL AND INSTALLATION ".