LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Communication Devices >> LAN System (Can) (Except Hybrid) >> DTC/Circuit Diagnosis >> CGW Branch Line Circuit (Can Communication Circuit 1) >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK DTC 

    Check DTC of the CAN gateway with CONSULT.

    Is U1010 or B2600 indicated? 

    YES: Perform a diagnosis of the indicated DTC.

    NO: GO TO 2.

  2. CHECK CONNECTOR 
    1. Turn the ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Check the terminals and connectors of the CAN gateway for damage, bend and loose connection (unit side and connector side).

      Is the inspection result normal? 

      YES: GO TO 3.

      NO: Repair the terminal and connector.

  3. CHECK HARNESS FOR OPEN CIRCUIT 
    1. Disconnect the connector of CAN gateway.
    2. Check the resistance between the CAN gateway harness connector terminals.
      CAN gateway harness connector Resistance (Ω)
      Connector No. Terminal No.
      M5 1 7 Approx. 54 - 66

      Is the measurement value within the specification? 

      YES: GO TO 4.

      NO: Repair the CAN gateway branch line (CAN communication circuit 1 side).

  4. CHECK POWER SUPPLY AND GROUND CIRCUIT 

    Check the power supply and the ground circuit of the CAN gateway. Refer to "DIAGNOSIS PROCEDURE ".

    Is the inspection result normal? 

    YES (Present error): Replace the CAN gateway. Refer to "REMOVAL AND INSTALLATION ".

    YES (Past error): Error was detected in the CAN gateway branch line (CAN communication circuit 1 side).

    NO: Repair the power supply and the ground circuit.

scientia non olet · About LEMON Manuals