LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2014 >> QX60 Base, FWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Driver Assistance System (DCA) (Except Hybrid) >> DTC/Circuit Diagnosis >> DTC C1F06: Can Circuit2 >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK SELF-DIAGNOSIS RESULTS 

    Check if "U1000" is detected other than "C1F06" in "Self Diagnostic Result" of "ACCELE PEDAL ACT".

    Is "U1000" detected? 

    YES: Perform the CAN communication system inspection. Repair or replace the malfunctioning parts. Refer to "ACCELERATOR PEDAL ACTUATOR: DTC Logic ".

    NO: GO TO  2.

  2. REPLACE ADAS CONTROL UNIT 
    1. Turn the ignition switch OFF.
    2. Replace the ADAS control unit. Refer to "REMOVAL AND INSTALLATION ".
    3. Erases All self-diagnosis results.
    4. Perform "All DTC Reading" again.
    5. Check if the "C1F06" is detected in self-diagnosis results of "ACCELE PEDAL ACT".

    Is "C1F06" detected? 

    YES: Replace the accelerator pedal assembly. Refer to "MODELS WITH DISTANCE CONTROL ASSIST SYSTEM: Removal and Installation ".

    NO: INSPECTION END

scientia non olet · About LEMON Manuals