Diagnosis Procedure

CHECK "AUTO LOCK SET" SETTING IN "WORK SUPPORT"
1. Select "INTELLIGENT KEY" of "BCM" using CONSULT.
2. Select "AUTO LOCK SET" in "WORK SUPPORT" mode.
3. Check "AUTO LOCK SET" setting in "WORK SUPPORT".
  Refer to "INTELLIGENT KEY: CONSULT FUNCTION (BCM - INTELLIGENT KEY) ".
  
  Is the inspection result normal?
  
  YES: GO TO 2.
  
  NO: Set "MODE 2", "MODE 3", "MODE 4", "MODE 5", "MODE 6" or "MODE 7" in "AUTO LOCK SET".
REPLACE BCM
- Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
- Confirm the operation after replacement.
  Is the result normal?
  
  YES: Inspection End.
  
  NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".