RH: Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK SPINDLE MOTOR INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Disconnect spindle unit RH connector.
   3. Check voltage between spindle unit RH harness connector and ground.

      (+)		(-)	Condition		Voltage (Approx.)
      Spindle unit RH
      Connector	Terminal
      B162	9	Ground	Back door	Auto open operation	16.75 - 8.5 V
      	2			Auto close operation

      Is the inspection result normal? 

      YES: Replace spindle unit RH. Refer to "SPINDLE UNIT: REMOVAL AND INSTALLATION ".

      NO: GO TO 2.

2. CHECK SPINDLE MOTOR CIRCUIT 
   1. Disconnect automatic back door control module connector.
   2. Check continuity between automatic back door control module harness connector and spindle unit harness connector.

      Automatic back door control module		Spindle unit RH		Continuity
      Connector	Terminal	Connector	Terminal
      B56	29	B162	9	Yes
      	36		2

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B56	29		No
      	36

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.