LH: Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK SPINDLE MOTOR INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Disconnect spindle unit LH connector.
   3. Check voltage between spindle unit LH harness connector and ground.

      (+)		(-)	Condition		Voltage (Approx.)
      Spindle unit LH
      Connector	Terminal
      B70	9	Ground	Back door	Auto open operation	16.75 - 8.5 V
      	2			Auto close operation

      Is the inspection result normal? 

      YES: Replace spindle unit LH. Refer to "SPINDLE UNIT: REMOVAL AND INSTALLATION ".

      NO: GO TO 2.

2. CHECK SPINDLE MOTOR CIRCUIT 
   1. Disconnect automatic back door control module connector.
   2. Check continuity between automatic back door control module harness connector and spindle unit LH harness connector.

      Automatic back door control module		Spindle unit LH		Continuity
      Connector	Terminal	Connector	Terminal
      B56	27	B70	9	Yes
      	34		2

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B56	27		No
      	34

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.