Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK DOOR REQUEST SWITCH INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Disconnect malfunctioning front door request switch connector.
   3. Check voltage between malfunctioning front door request switch harness connector and ground.

      (+)			(-)	Voltage (Approx.)
      Front door request switch
      Connector		Terminal
      Driver side	D15	1	Ground	12 V
      Passenger side	D115

      Is the inspection result normal? 

      YES: GO TO  3.

      NO: GO TO 2.

2. CHECK DOOR REQUEST SWITCH CIRCUIT 
   1. Disconnect BCM connector.
   2. Check continuity between malfunctioning front door request switch harness connector and BCM harness connector.

      Front door request switch			BCM		Continuity
      Connector		Terminal	Connector	Terminal
      Driver side	D15	1	M19	71	Yes
      Passenger side	D115			72

   3. Check continuity between malfunctioning front door request switch harness connector and ground.

      Front door request switch			Ground	Continuity
      Connector		Terminal
      Driver side	D15	1		No
      Passenger side	D115

      Is the inspection result normal? 

      YES: Replace BCM. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

3. CHECK DOOR REQUEST SWITCH GROUND CIRCUIT 

   Check continuity between malfunctioning front door request switch harness connector and ground.

   Front door request switch			Ground	Continuity
   Connector		Terminal
   Driver side	D15	2		Yes
   Passenger side	D115

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair or replace harness.

4. CHECK DOOR REQUEST SWITCH 

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 5.

   NO: Replace malfunctioning front outside handle assembly. Refer to "DRIVER SIDE: REMOVAL AND INSTALLATION " or "PASSENGER SIDE: REMOVAL AND INSTALLATION ".

5. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   : Inspection End.