Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK FOR FOREIGN MATERIALS IN BACK DOOR LOCK ASSEMBLY 

   Check for entry of foreign materials in back door lock assembly.

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Remove foreign materials.

2. CHECK BACK DOOR OPEN/CLOSE OPERATION 

   Manually check open and close operation of back door.

   Is the inspection result normal? 

   YES: GO TO 3.

   NO: Repair or replace the malfunctioning parts.

3. CHECK OPEN SWITCH SIGNAL 
   1. Select AUTOMATIC BACK DOOR CONTROL MODULE using CONSULT.
   2. Select OPEN SW in DATA MONITOR mode.
   3. Check that the function operates normally according to the following conditions.

      Monitor item	Condition		Status
      OPEN SW	Back door	Fully closed/Half latch	OFF
      		Open	ON

      Is the inspection result normal? 

      YES: GO TO  8.

      NO: GO TO 4.

4. CHECK OPEN SWITCH INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Disconnect back door lock assembly connector.
   3. Check voltage between back door lock assembly harness connector and ground.

      (+)		(-)	Voltage (Approx.)
      Back door lock assembly
      Connector	Terminal
      D557	4	Ground	16 - 8 V

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 5.

5. CHECK OPEN SWITCH CIRCUIT 
   1. Disconnect automatic back door control module connector.
   2. Check continuity between automatic back door control module harness connector and back door lock assembly harness connector.

      Automatic back door control module		Back door lock assembly		Continuity
      Connector	Terminal	Connector	Terminal
      B55	11	D557	4	Yes

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B55	11		No

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

6. CHECK OPEN SWITCH GROUND CIRCUIT 

   Check continuity between back door lock assembly harness connector and ground.

   Back door lock assembly		Ground	Continuity
   Connector	Terminal
   D557	8		Yes

   Is the inspection result normal? 

   YES: GO TO 7.

   NO: Repair or replace harness.

7. CHECK OPEN SWITCH 

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 8.

   NO: Replace back door lock assembly. Refer to "DOOR LOCK: REMOVAL AND INSTALLATION ".

8. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   : Inspection End.