Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK BACK DOOR WARNING CHIME POWER SUPPLY CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect back door warning chime connector.
   3. Check voltage between back door warning chime harness connector and ground.

      (+)		(-)	Voltage (Approx.)
      Back door warning chime
      Connector	Terminal
      B402	1	Ground	Battery voltage

      Is the inspection result normal? 

      YES: GO TO  3.

      NO: GO TO 2.

2. CHECK BACK DOOR WARNING CHIME OUTPUT SIGNAL CIRCUIT 
   1. Disconnect automatic back door control module connector.
   2. Check continuity between automatic back door control module harness connector and back door warning chime harness connector.

      Automatic back door control module		Back door warning chime		Continuity
      Connector	Terminal	Connector	Terminal
      B56	37	B402	1	Yes

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B56	37		No

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

3. CHECK BACK DOOR WARNING CHIME GROUND CIRCUIT 

   Check continuity between back door warning chime harness connector and ground.

   Back door warning chime		Ground	Continuity
   Connector	Terminal
   B402	2		Yes

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair or replace harness.

4. CHECK BACK DOOR WARNING CHIME 

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 5.

   NO: Replace back door warning chime. Refer to "REMOVAL AND INSTALLATION ".

5. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   : Inspection End.