Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

1. CHECK AUTOMATIC BACK DOOR SWITCH INPUT SIGNAL 
   1. Turn ignition switch OFF.
   2. Disconnect automatic back door switch connector.
   3. Check voltage between automatic back door switch harness connector and ground.

      (+)		(-)	Voltage (Approx.)
      Automatic back door switch
      Connector	Terminal
      M186	1	Ground	Battery voltage

      Is the inspection result normal? 

      YES: GO TO  3.

      NO: GO TO 2.

2. CHECK AUTOMATIC BACK DOOR SWITCH CIRCUIT 
   1. Disconnect automatic back door control module connector.
   2. Check continuity between automatic back door control module harness connector and automatic back door switch harness connector.

      Automatic back door control module		Automatic back door switch		Continuity
      Connector	Terminal	Connector	Terminal
      B55	22	M186	1	Yes

   3. Check continuity between automatic back door control module harness connector and ground.

      Automatic back door control module		Ground	Continuity
      Connector	Terminal
      B55	22		No

      Is the inspection result normal? 

      YES: Replace automatic back door control module. Refer to "REMOVAL AND INSTALLATION ".

      NO: Repair or replace harness.

3. CHECK AUTOMATIC BACK DOOR SWITCH GROUND CIRCUIT 

   Check continuity between automatic back door switch harness connector and ground.

   Automatic back door switch		Ground	Continuity
   Connector	Terminal
   M186	2		Yes

   Is the inspection result normal? 

   YES: GO TO 4.

   NO: Repair or replace harness.

4. CHECK AUTOMATIC BACK DOOR SWITCH 

   Refer to "COMPONENT INSPECTION ".

   Is the inspection result normal? 

   YES: GO TO 5.

   NO: Replace automatic back door switch. Refer to "REMOVAL AND INSTALLATION ".

5. CHECK INTERMITTENT INCIDENT 

   Refer to "INTERMITTENT INCIDENT ".

   : Inspection End.