Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM - WITH AUTOMATIC DRIVE POSITIONER " or "WIRING DIAGRAM - WITHOUT AUTOMATIC DRIVE POSITIONER ".

1. CHECK WASHER FLUID LEVEL SWITCH SIGNAL CIRCUIT 
   1. Turn ignition switch OFF.
   2. Disconnect combination meter harness connector M24 and washer fluid level switch harness connector E208.
   3. Check continuity between combination meter harness connector M24 and washer fluid level switch harness connector E208.

      Combination meter		Washer fluid level switch		Continuity
      Connector	Terminal	Connector	Terminal
      M24	49	E208	1	Yes

   4. Check continuity between combination meter harness connector and ground.

      Combination meter		Ground	Continuity
      Connector	Terminal
      M24	49		No

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair or replace harness or connectors.

2. CHECK WASHER FLUID LEVEL SWITCH GROUND CIRCUIT 

   Check continuity between washer fluid level switch connector and ground.

   Washer fluid level switch		Ground	Continuity
   Connector	Terminal
   E208	2		Yes

   Is the inspection result normal? 

   YES: Inspection End.

   NO: Repair or replace harness or connectors.