COMBINATION METER: Diagnosis Procedure
- CHECK FUSE
Check for blown fuses.
Power source Fuse No. Battery 6 Ignition switch ON or START 11 Ignition switch ON or ACC 1 Is the inspection result normal?
YES: GO TO 2.
NO: Be sure to eliminate cause of malfunction before installing new fuse.
- CHECK POWER SUPPLY CIRCUIT
Check voltage between combination meter harness connector and ground.
Terminals Ignition switch position Voltage (Approx.) (+) (-) Combination meter Ground Connector Terminal M58 45 OFF Battery voltage 46 ON M57 14 ACC Is the inspection result normal?
YES: GO TO 3.
NO: Check harness between combination meter and fuse.
- CHECK GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter connector.
- Check continuity between combination meter harness connector and ground.
Combination meter Ground Continuity Connector Terminal M57 1 Existed M58 52 Is the inspection result normal?
YES: INSPECTION END
NO: Repair harness or connector.