Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and meter control switch connector.
3. Check continuity between combination meter harness connector and meter control switch harness connector.

   Terminals				Continuity
   Combination meter		Meter control switch
   Connector	Terminal	Connector	Terminal
   M57	17	M59	4	Existed
   	18		5
   	36		6
   	37		7

4. Check continuity between combination meter harness connector and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M57	17		Not existed
   	18
   	36
   	37

   Is the inspection result normal? 

   YES: GO TO 2.

   NO: Repair harness or connector.

Check meter control switch. Refer to "COMPONENT INSPECTION ".

Is the inspection result normal? 

YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".

NO: Replace meter control switch. Refer to "REMOVAL AND INSTALLATION ".