Component Inspection
- CHECK METER CONTROL SWITCH
- Turn ignition switch OFF.
- Disconnect meter control switch connector.
- Check meter control switch.
Terminals Condition Continuity Meter control switch 1 2 When enter switch is pressed Existed Other than the above Not existed 11 When select switch is pressed Existed Other than the above Not existed 6 When illumination control switch (+) is pressed Existed Other than the above Not existed 3 When illumination control switch (-) is pressed Existed Other than the above Not existed 12 When trip reset switch is pressed Existed Other than the above Not existed Is the inspection result normal?
YES: INSPECTION END
NO: Replace meter control switch. Refer to "REMOVAL AND INSTALLATION ".