| Combination meter |
Controls the following with the signals received from each unit via CAN communication and the signals from switches and sensors:
- Speedometer
- Tachometer
- Engine coolant temperature gauge
- Fuel gauge
- Warning lamps
- Indicator lamps
- Meter illumination control
- Meter effect function
- Information display
|
| Meter control switch |
Transmits the following signals to the combination meter:
- Trip reset switch signal
- Illumination control switch signal (+)
- Illumination control switch signal (-)
|
| ECM |
Transmits the following signals to the combination meter via CAN communication:
- Engine speed signal
- Engine coolant temperature signal
- Engine oil pressure warning signal
- Fuel consumption monitor signal
|
| ABS actuator and electric unit (control unit) |
Transmits the vehicle speed signal to the combination meter via CAN communication. |
| Power steering control module |
Transmits the EPS signal to the combination meter via CAN communication. |
| BCM |
Transmits the following signals to the combination meter via CAN communication:
- Tire pressure information
- Position light request signal
- Low tire pressure warning lamp signal
- Door switch signal
- Back door switch signal
|
| TCM |
Transmits the following signals to the combination meter via CAN communication:
- Shift position signal
- Manual mode shift refusal signal
|
| CVT shift selector |
Transmits the following signals to the combination meter:
- Manual mode signal
- Non-manual mode signal
- Manual mode shift up signal
- Manual mode shift down signal
|
| Fuel level sensor unit |
Transmits the fuel level sensor signal to the combination meter. |
| Seat belt buckle switch (driver seat) |
Transmits the seat belt buckle switch (driver seat) signal to the combination meter. |
| Air bag diagnosis sensor unit |
Transmits the seat belt buckle switch (passenger seat) signal to the combination meter. |
| Engine oil pressure sensor |
Transmits the engine oil pressure sensor signal to the ECM. |
| Ambient sensor |
Transmits the ambient sensor signal to the A/C auto amp. |
| A/C auto amp. |
Transmits the following signals to the combination meter via CAN communication:
- Ambient sensor signal
- Drive mode select switch signal
|
| Parking brake switch |
Transmits the parking brake switch signal to the combination meter. |
| Washer fluid level switch |
Transmits the washer fluid level switch signal to the combination meter. |
| Steering switch |
Transmits the following signals to the information display:
- Display signal
- Menu up signal
- Menu down signal
- Enter signal
- Back signal
|
| ADAS control unit (if equipped) |
Refer to
"SYSTEM FUNCTION
". |
| Drive mode select switch |
Refer to
"INFINITI DRIVE MODE SELECTOR
". |
| Brake fluid level switch |
Transmits the brake fluid level switch signal to the combination meter. |