LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> G37 Base >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door & Lock (Convertible) >> DTC/Circuit Diagnosis >> Power Supply And Ground Circuit >> Retractable Hard Top Control Unit >> RETRACTABLE HARD TOP CONTROL UNIT: Diagnosis Procedure

RETRACTABLE HARD TOP CONTROL UNIT: Diagnosis Procedure

  1. CHECK FUSE AND FUSIBLE LINK 

    Check that the following fuse and fusible link are not blown.

    Signal name Fuse and fusible link No.
    Battery power supply O

    Is the fuse fusing? 

    YES: Replace the blown fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown.

    NO: GO TO 2.

  2. CHECK POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect retractable hard top control unit connectors.
    3. Check voltage between retractable hard top control unit harness connector and ground.
      Terminals Voltage (Approx.)
      (+) (-)
      Retractable hard top control unit Ground
      Connector Terminal
      B84 57 Battery voltage
      58
      59

      Is the measurement value normal? 

      YES: GO TO 3.

      NO: Repair harness or connector.

  3. CHECK GROUND CIRCUIT 

    Check continuity between retractable hard top control unit harness connector and ground.

    Retractable hard top control unit Ground Continuity
    Connector Terminal
    B84 60 Existed
    61

    Does continuity exist? 

    YES: INSPECTION END

    NO: Repair harness or connector.

scientia non olet · About LEMON Manuals