Diagnosis Procedure
- CHECK OIL PRESSURE WARNING LAMP
Perform auto active test of IPDM E/R. Refer to "DIAGNOSIS DESCRIPTION ".
Is oil pressure warning lamp illuminated?
YES: GO TO 2.
NO: GO TO 5.
- CHECK IPDM E/R OUTPUT VOLTAGE
- Disconnect the oil pressure switch connector.
- Turn ignition switch ON.
- Check voltage between the oil pressure switch harness connector terminal and ground.
Terminals Voltage (Approx.) (+) (-) Oil pressure switch Connector Terminal F37 1 Ground 12 V Is the inspection result normal?
YES: GO TO 3.
NO: GO TO 4.
- CHECK OIL PRESSURE SWITCH
Check the oil pressure switch. Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".
NO: Replace oil pressure switch.
- CHECK OIL PRESSURE SWITCH SIGNAL CIRCUIT
Check the oil pressure switch signal circuit. Refer to "DIAGNOSIS PROCEDURE ".
Is the inspection result normal?
YES: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".
NO: Repair harness or connector.
- CHECK UNIFIED METER AND A/C AMP. INPUT SIGNAL
- Connect the CONSULT.
- Select the "Data Monitor" of the "METER/M&A" and check the "OIL W/L" monitor value. Refer to
"COMPONENT FUNCTION CHECK ".
Is the inspection result normal?
YES: Replace combination meter.
NO: Replace IPDM E/R. Refer to "REMOVAL AND INSTALLATION ".