LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case) >> Unit Disassembly And Assembly >> Front Drive Shaft And Drive Chain >> VQ37VHR >> VQ37VHR: Disassembly

VQ37VHR: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Separate front case and rear case. Refer to "VQ37VHR: DISASSEMBLY ".
  2. Remove drive chain and front drive shaft.
    CAUTION: Never use tools. Always remove by hand.
  3. Remove front drive shaft front bearing with the drift (A) and replacer (B).
    Fig 1: Removing Front Drive Shaft Front Bearing Using Drift And Replacer
    G09002679Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove front drive shaft rear bearing with the drift (A) and replacer (B).
    Fig 2: Removing Front Drive Shaft Rear Bearing Using Drift And Replacer
    G09002680Courtesy of NISSAN NORTH AMERICA, INC.
  5. Remove plug from front drive shaft.
scientia non olet · About LEMON Manuals