LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case) >> Unit Disassembly And Assembly >> Front Drive Shaft And Drive Chain >> VQ37VHR >> VQ37VHR: Assembly

VQ37VHR: Assembly

WARNING: This page is about a different variant/trim than selected.
  1. Install plug to front drive shaft.
    CAUTION: Never reuse plug.
  2. Install front drive shaft front bearing with the drift (A) [SST: ST33200000 (J-26082)].
    Fig 1: Installing Front Drive Shaft Front Bearing Using Drift
    G05979454Courtesy of NISSAN NORTH AMERICA, INC.
  3. Install front drive shaft rear bearing with the drift (A) [SST: KV38104010 (-)].
    Fig 2: Installing Front Drive Shaft Rear Bearing Using Drift
    G05979455Courtesy of NISSAN NORTH AMERICA, INC.
  4. Set drive chain to front drive shaft.
    CAUTION: Identification mark (A) of drive chain should be in the side of front bearing (1) of front drive shaft.
    Fig 3: Locating Drive Chain Identification Mark And Drive Shaft Front Bearing
    G05727203Courtesy of NISSAN NORTH AMERICA, INC.
  5. Install drive chain to main shaft, and then install front drive shaft.
    CAUTION: Never use tools. Always install by hand.
  6. Install front case to rear case. Refer to "VQ37VHR: ASSEMBLY ".
scientia non olet · About LEMON Manuals