Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK TIRE
Check the following.
- Tire pressure
- Wear condition
- Front and rear tire size (There is no difference between front and rear tires.)
  Is the inspection result normal?
  
  YES: GO TO 2.
  
  NO: Repair or replace error-detected parts. And then, drive the vehicle at speed of 20 km/h (12 MPH) or more for 5 seconds or more. Improper size information is initialized accordingly.
CHECK INPUT SIGNAL OF TIRE DIAMETER
With CONSULT
1. Start the engine.
2. Drive at 20 km/h (12 MPH) or more for approximately 4 minutes.
3. Check "DIS-TIRE MONI" of CONSULT "DATA MONITOR" for "ALL MODE AWD/4WD".
  Does the item on "DATA MONITOR" indicate "0 - 4 mm"?
  
  YES: INSPECTION END
  
  NO: GO TO 3.
TERMINAL INSPECTION
Check AWD control unit harness connector for disconnection.

Is the inspection result normal?

YES: Replace AWD control unit. Refer to "EXPLODED VIEW ".

NO: Repair or replace the error-detected parts.