Diagnosis Procedure
WARNING: This page is about a different variant/trim than selected.
- PERFORM ECM SELF-DIAGNOSIS
With CONSULT
Perform self-diagnosis for "ENGINE".
Is any DTC detected?
YES: Check the DTC.
NO: GO TO 2.
- PERFORM SELF-DIAGNOSIS
With CONSULT
- Erase self-diagnostic results for "ALL MODE AWD/4WD".
- Turn the ignition switch OFF.
- Start the engine. Drive the vehicle for a while.
- Stop the vehicle. Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "C1210" detected?
YES: Replace AWD control unit. Refer to "EXPLODED VIEW ".
NO: Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.