LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Front Axle (AWD)) >> Removal And Installation >> Front Drive Shaft >> Wheel Side >> WHEEL SIDE: Disassembly and Assembly >> Disassembly

WHEEL SIDE: Disassembly and Assembly: Disassembly

WARNING: This page is about a different variant/trim than selected.
  1. Fix shaft with a vise.
    CAUTION: Protect shaft when fixing with a vise using aluminum or copper plates.
  2. Remove boot bands, and then remove boot from joint sub-assembly.
  3. Screw drive shaft puller (commercial service tool) (A) 30 mm (1.18 in) or more into the thread of joint sub-assembly, and pull joint sub-assembly from shaft.
    CAUTION:
    • If joint sub-assembly cannot be removed after five or more unsuccessful attempts, replace shaft and joint sub assembly as a set.
    • Align sliding hammer and drive shaft and remove them by pulling directory.
    Fig 1: Removing Joint Sub-Assembly From Shaft Using Screw Drive Shaft Puller
    G05915131Courtesy of NISSAN NORTH AMERICA, INC.
  4. Remove circular clip from shaft.
  5. Remove boot from shaft.
  6. Clean old grease on joint sub-assembly with paper waste while rotating ball cage.
scientia non olet · About LEMON Manuals