LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Front Suspension (AWD)) >> Removal And Installation >> Front Coil Spring And Shock Absorber >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove engine cover. Refer to "EXPLODED VIEW " (VQ37VHR), "EXPLODED VIEW " (VK50VE).
  2. Remove front fender protector. Refer to "FENDER PROTECTOR: EXPLODED VIEW ".
  3. Remove tires with power tool.
  4. Remove wheel sensor and harness connector from vehicle. Refer to "FRONT WHEEL SENSOR: EXPLODED VIEW ".
    CAUTION: Never pull on wheel sensor harness.
  5. Remove shock absorber actuator harness connector (with Continuous Damping Control).
  6. Remove front wheel vertical G sensor (with Continuous Damping Control). Refer to "EXPLODED VIEW ".
  7. Remove brake hose bracket. Refer to "FRONT: EXPLODED VIEW ".
  8. Remove stabilizer connecting rod with power tool. Refer to "EXPLODED VIEW ".
  9. Remove wheel hub lock nut. Refer to "EXPLODED VIEW ".
  10. Remove shock absorber from transverse link with power tool.
  11. Separate upper link from steering knuckle. Refer to "EXPLODED VIEW ".
  12. Separate drive shaft from wheel hub and bearing assembly.
  13. Remove shock absorber assembly.
    NOTE: If removing shock absorber is difficult, loosen upper link mounting bolts (vehicle side).
scientia non olet · About LEMON Manuals