Removal and Installation: Installation

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

Note the following items, and install in the reverse order of removal.

Check for deformation of the grommets (No. 13 of Components).
Insert the collar (No. 12 of Components) vertically.
Temporarily tighten bolts and nuts when installing exhaust pipe assembly. Tighten them to the specified torque when connecting the vehicle rear to the vehicle front.

CAUTION:

Always replace exhaust tube gaskets with new ones when reassembling.
Prevent rust preventatives from contacting the sensor body.
If heat insulator is badly deformed, repair or replace it. If deposits such as mud pile up on the heat insulator, remove them.
When installing heat insulator avoid large gaps or interference between heat insulator and each exhaust pipe.
Remove deposits from the sealing surface of each connection. Connect them securely to avoid gases leakage.
Check each part for unusual interference, and then tighten them to the specified torque.
When installing each mounting rubber, avoid twisting or unusual extension in up/down and right/left directions.