High And Low Reverse Clutch: Assembly

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

Install high and low reverse clutch component part (dish plate, drive plates, driven plates, and retaining plate) to high and low reverse clutch drum.

Fig 1: Identifying High And Low Reverse Clutch Component Parts
Courtesy of NISSAN NORTH AMERICA, INC.

CAUTION: Check the order of plates.
Install snap ring to high and low reverse clutch drum using a flat-bladed screwdriver.
CAUTION:
- Be careful not to scratch high and low reverse clutch drum.
- Be careful not to damage snap ring.
Fig 2: Installing Snap Ring To High And Low Reverse Clutch Drum Using Flat-Bladed Screwdriver
Courtesy of NISSAN NORTH AMERICA, INC.
Install bearing race to high and low reverse clutch drum.
CAUTION: Check the direction of needle bearing. Refer to "LOCATION OF NEEDLE BEARINGS AND BEARING RACES ".

Fig 3: Installing Bearing Race To High And Low Reverse Clutch Drum
Courtesy of NISSAN NORTH AMERICA, INC.