Removal and Installation: Installation
WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
Note the following, and install in the reverse order of removal.
CAUTION:
Never reuse copper washer.
- Refer to the following when installing A/T fluid cooler hoses.
| Hose name | Hose end | Paint mark | Position of hose clamp(1) | ||
|---|---|---|---|---|---|
| A/T fluid cooler hose A | Radiator assembly side | Facing backward | A | ||
| A/T fluid cooler tube side | Facing downward | B | |||
| A/T fluid cooler hose B | Radiator assembly side | Facing downward | C | ||
| A/T fluid cooler tube side | Facing downward | B | |||
|
|||||
- The illustrations indicate the view from the hose ends.
- When installing hose clamps center line of each hose clamp tab should be positioned as shown in the figure below.
- Insert A/T fluid cooler hoses according to dimension "L" described below.
(1) (2) Tube type Dimension "L" A/T fluid cooler hose A Radiator assembly side A End reaches the radius curve end. A/T fluid cooler tube side B 30 mm (1.18 in) [End reaches the 2-stage bulge (D).] A/T fluid cooler hose B Radiator assembly side C Insert the hose until the hose touches the radiator. A/T fluid cooler tube side B 30 mm (1.18 in) [End reaches the 2-stage bulge (D).] - Set hose clamps (1) at the both ends of A/T fluid cooler hoses (2) with dimension "A" from the hose edge.
Dimension "A": 5 - 9 mm (0.20 - 0.35 in)
- Hose clamp should not interfere with the bulge of fluid cooler tube.