Component Inspection (Selector Lever Position Indicator)

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SELECTOR LEVER POSITION INDICATOR

Check that selector lever position indicator lamps turn on.

CAUTION: Connect the fuse between the terminals when applying the voltage.

Selector lever position indicator connector			Condition	Status
Connector	Terminal
Connector	+ (fuse)	-
M223	1	9	Apply 12 V direct current between terminals 1 and 9.	Illumination lamp turns on.
	3	8	Apply 12 V direct current between terminals 3 and 8.	"N" position indicator lamp turns on.
	4		Apply 12 V direct current between terminals 4 and 8.	"D" position indicator lamp turns on.
	5		Apply 12 V direct current between terminals 5 and 8.	"R" position indicator lamp turns on.
	7		Apply 12 V direct current between terminals 7 and 8.	"P" position indicator lamp turns on.
	6	2	Apply 12 V direct current between terminals 6 and 2.	"M" mode indicator lamp turns on.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace the selector lever position indicator. Refer to "EXPLODED VIEW ".