LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Automatic Transmission) >> DTC/Circuit Diagnosis >> DTC U1000: Can Comm Circuit >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    : GO TO 2.

  2. CHECK DTC DETECTION 

    With CONSULT 

    1. Start the engine.
    2. Run engine for at least 2 consecutive seconds at idle speed.
    3. Perform "Self Diagnostic Results" in "TRANSMISSION".

    With GST 

    Follow the procedure "With CONSULT".

    Is "U1000" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About LEMON Manuals