DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

: GO TO 2.
CHECK DTC DETECTION
With CONSULT
1. Start the engine.
2. Select "BATTERY VOLT", "MANU MODE SW", "GEAR" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 5 seconds or more.
  BATTERY VOLT: 9 V or more
  
  MANU MODE SW: ON
  
  GEAR: 1st
  
  VHCL/S SE-A/T: 10 km/h (7 MPH) or more
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST

Follow the procedure "With CONSULT".

Is "P2722" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END