DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

: GO TO 2.
CHECK DTC DETECTION
With CONSULT
1. Start the engine.
2. Select "SLCT LVR POSI", "ACCELE POSI" and "GEAR" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions.
  SLCT LVR POSI: D
  
  ACCELE POSI: More than 1.0/8
  
  GEAR: 3rd → 4th → 5th → 6th → 7th
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST

Follow the procedure "With CONSULT".

Is "P0780" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END