DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

: GO TO 2.
CHECK DTC DETECTION
With CONSULT
1. Start the engine.
2. Select "BATTERY VOLT" and "SLCT LVR POSI" in "Data Monitor" in "TRANSMISSION".
3. Shift the selector lever to "N" position.
4. Maintain the following conditions for 5 seconds or more.
  BATTERY VOLT: 9 V or more
  
  SLCT LVR POSI: N/P
5. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST

Follow the procedure "With CONSULT".

Is "P0745" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: INSPECTION END