DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

" "DIAGNOSIS PROCEDURE " must be performed before starting "DTC CONFIRMATION PROCEDURE".
Never perform "DTC CONFIRMATION PROCEDURE" before completing the repair, which may cause secondary malfunction.
Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

: GO TO 2.
CHECK ATF TEMPERATURE
With CONSULT
1. Start the engine.
2. Select "ATF TEMP 1" in "Data Monitor" in "TRANSMISSION".
3. Check ATF temperature is in the following range.
  ATF TEMP 1: 20°C (68°F) - 140°C (284°F)
With GST
1. Start the engine.
2. Drive vehicle for approximately 5 minutes in urban areas.
  Is ATF temperature within specified range?
  
  YES: GO TO 3.
  
  NO: Drive vehicle to warm ATF or stop engine to cool ATF.
CHECK SYMPTOM (PART 1)
With CONSULT
1. Select "3RD GR FNCTN P0733" in "DTC & SRT confirmation" in "TRANSMISSION".
2. Drive vehicle with manual mode and maintain the following conditions.
  GEAR: 3rd
  
  ACCELE POSI: 0.7/8 or more
  
  VEHICLE SPEED: 10 km/h (7 MPH) or more
3. Keep the current driving status for 2 seconds or more if CONSULT screen changes from "OUT OF CONDITION" to "TESTING".
  CAUTION: When "TESTING" is not detected on CONSULT for a long time, check "Self Diagnostic Results" in "TRANSMISSION". When a DTC other than "P0733" is detected, check the DTC. Refer to "DTC INDEX ".
With GST
1. Drive vehicle and maintain the following conditions for 2 seconds or more.
  Selector lever: "M" position
  
  Gear position: 3rd
  
  Accelerator pedal opening: 0.7/8 or more
  
  Vehicle speed: 10 km/h (7 MPH) or more
2. Check DTC.
  Is "OUT OF CONDITION", "STOP VEHICLE" or "COMPLETED RESULT NG" displayed?/Is "P0733" detected?
  
  YES-1: "OUT OF CONDITION": Perform "Step 3" again.
  
  YES-2: "STOP VEHICLE": GO TO 4.
  
  YES-3: "COMPLETED RESULT NG": Go to "DIAGNOSIS PROCEDURE ".
  
  YES-4: "P0733" is detected: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: GO TO 4.
CHECK SYMPTOM (PART 2)
1. Stop vehicle.
2. Drive vehicle in "D" position allowing it to shift from 1GR to 7GR gear and check shift timing and shift shock.
  : INSPECTION END