DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Always drive vehicle at a safe speed.

PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

: GO TO 2.
CHECK DTC DETECTION
With CONSULT
1. Start the engine.
2. Select "SLCT LVR POSI" and "VHCL/S SE-A/T" in "Data Monitor" in "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for 14 minutes or more.
  SLCT LVR POSI: D
  
  VHCL/S SE-A/T: 10 km/h (7 MPH) or more
4. Perform "Self Diagnostic Results" in "TRANSMISSION".
With GST

Follow the procedure "With CONSULT".

Is "P0710" detected?

YES: Go to "DIAGNOSIS PROCEDURE ".

NO: GO TO 3.
CHECK A/T FLUID TEMPERATURE SENSOR FUNCTION
With CONSULT
1. Select "ATF TEMP 1" in "Data Monitor" in "TRANSMISSION".
2. Select "COOLANT TEMP" in "Data Monitor" in "ENGINE".
3. Check temperature difference between A/T fluid and engine coolant.
With GST
1. Complete engine diagnoses P0111, P0116, and P0196.
2. After starting the engine start, run the engine at idle for 5 minutes.
  Is the temperature calculated by subtracting engine coolant temperature from A/T fluid temperature more than 33°C (91.4°F) or is it less than -19°C (-2.2°F)? (With CONSULT)/Is "P0710" detected? (With GST)
  
  YES: Go to "DIAGNOSIS PROCEDURE ".
  
  NO: INSPECTION END.