Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be careful not to get burned, as engine oil and engine coolant may be hot.

Remove engine undercover with power tool.
Drain engine coolant from radiator. Refer to "DRAINING ".
Remove the following parts:
- Engine room cover: Refer to "EXPLODED VIEW ".
- Reservoir tank: Refer to "EXPLODED VIEW ".
- Alternator, water pump and A/C compressor belt: Refer to "EXPLODED VIEW ".
Remove water suction pipe mounting bolt. Refer to "EXPLODED VIEW ".
Disconnect water hoses and water pipe.
- When removing oil cooler only, pinch water hoses near oil cooler to prevent engine coolant from spilling out.
- Remaining engine coolant in piping will come out. Use a tray to collect it.
  CAUTION:
  - Perform this step when the engine is cold.
  - Never spill engine coolant on drive belts.
Remove oil filter. Refer to "REMOVAL AND INSTALLATION ".
Loosen connector bolt, and remove oil cooler.
CAUTION: Never spill engine oil on rubber parts such as drive belts and engine mounting insulator.