LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Cooling System) >> Removal And Installation >> Water Pump >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove following parts:
    • Engine undercover, using a power tool.
    • Engine cover and engine room cover (RH and LH). Refer to "EXPLODED VIEW ".
    • Air duct (inlet): Refer to "EXPLODED VIEW ".
    • Reservoir tank. Refer to "EXPLODED VIEW ".
  2. Loosen water pump pulley mounting bolts.
  3. Remove alternator, water pump and A/C compressor belt: Refer to "REMOVAL AND INSTALLATION ".
  4. Remove water pump pulley.
  5. Drain engine coolant from drain plugs on radiator and cylinder block. Refer to "DRAINING " and "ENGINE STAND SETTING ".
    CAUTION:
    • Perform this step when engine is cold.
    • Never spill engine coolant on drive belt.
  6. Remove water pump. Refer to "EXPLODED VIEW ".
    • Engine coolant will leak from cylinder block, so have a receptacle ready under vehicle.
      CAUTION:
      • Handle the water pump vane so that it does not contact any other parts.
      • Never disassemble water pump.
scientia non olet · About LEMON Manuals