LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Engine Cooling System) >> Removal And Installation >> Water Inlet And Thermostat Assembly >> Removal and Installation >> Removal

Removal and Installation: Removal

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine cover and engine room cover (RH and LH). Refer to "EXPLODED VIEW ".
  2. Remove air duct (inlet). Refer to "EXPLODED VIEW ".
  3. Remove reservoir tank. Refer to "EXPLODED VIEW ".
  4. Remove engine undercover with a power tool.
  5. Drain engine coolant from drain plugs on radiator and cylinder block. Refer to "DRAINING " and "ENGINE STAND SETTING ".
    CAUTION:
    • Perform this step when engine is cold.
    • Never spill engine coolant on drive belts.
  6. Disconnect radiator hose (upper and lower). Refer to "EXPLODED VIEW ".
  7. Remove intake manifold. Refer to "EXPLODED VIEW ".
  8. Remove water suction pipe and water suction hose.
  9. Remove water inlet and thermostat.
  10. Remove water connector, heater pipes and heater hoses.
  11. Remove thermostat housing.
scientia non olet · About LEMON Manuals