LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Control System - DTCS P0460 Through P1211) >> DTC P1091: VVEL Actuator Motor Relay >> Component Inspection

Component Inspection

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK VVEL ACTUATOR MOTOR RELAY 
    1. Turn ignition switch OFF.
    2. Remove VVEL actuator motor relay.
    3. Check the continuity between VVEL actuator motor relay terminals under the following conditions.
      Terminal Condition Continuity
      3 and 5 12V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed
      Fig 1: Checking VVEL Actuator Motor Relay
      G09001497Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: INSPECTION END

      NO: Replace VVEL actuator motor relay.

scientia non olet · About LEMON Manuals