LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2013 >> FX37 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Engine Control System - DTCS P0460 Through P1211) >> DTC P1090,: P1093 VVEL Actuator Motor >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2013 Infiniti FX50. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

      TESTING CONDITION: 

      Before performing the following procedure, confirm that battery voltage is more than 10 V at idle. 

      : GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and let it idle for 10 second.
    2. Keep the engine speed at approximately 3, 500 RPM for at least 10 seconds under no load.
    3. Check DTC.

      Is DTC detected? 

      YES: Go to "DIAGNOSIS PROCEDURE ".

      NO: INSPECTION END

scientia non olet · About LEMON Manuals